The store will not work correctly when cookies are disabled.
Join the Aqua Science Insiders Club
41 years of Expertise in Engineered Water Treatment and Well SystemsPrice Match GuaranteeLifetime WarrantyThe Largest Selection of Residential Filtration SystemsWell Water Components and SuppliesReplaceable FiltersComplete Water TestingIndustry’s Best BrandsExcellent Tech SupportWater Treatment ChemicalsCustom solutions designed to address your specific needsMost products ship the same day
Goulds Balanced Flow Constant Pressure System model 7GP1530 is a ProPak kit built for constant pressure performance with a 3 HP, 230 V three-phase motor, Aquavar SOLO controller with transducer, and Goulds 7GS15 GS water end. This 7 GPM system is rated at 60 PSI and designed for wells up to 690 ft. The controller converts single phase to three phase, supports 0-100 PSI adjustment with a 50 PSI factory preset, and helps deliver city-like pressure while using only a small inline pressure tank.
It includes a CentriPro 3 HP, 230 V three-phase motor, a CentriPro Aquavar SOLO controller with transducer, and a Goulds 7GS15 GS water end.
What flow rate and pressure is this system listed for?
This model is listed as 7 GPM at 60 PSI.
What well depth is this system designed for?
It is designed for wells up to 690 ft.
What is the pressure adjustment range?
The system offers 0-100 PSI pressure adjustment and is factory preset at 50 PSI.
Does this system need a large pressure tank?
No. The product information states that only a small inline pressure tank is needed.
Can the controller be mounted outdoors?
Yes. The wall-mounted controller is described as NEMA 3 rated and can be mounted outside.
How is the system wired?
The product information states wiring is like a standard three-wire control box: L1, L2, and ground in from the power supply, with red, yellow, black, and ground out to the motor.
What pump features are called out for durability?
The Goulds GS pump is described as stainless steel with sand and abrasion resistant design and a floating stack design.
This constant pressure system uses a wall-mounted controller, transducer, motor, and GS water end as part of the ProPak kit.
Review the included product literature and confirm the correct model for the required flow, pressure, and well depth.
Mount the controller in an appropriate location; the product information states the wall-mounted controller is NEMA 3 rated and can be mounted outside.
Make the controller wiring connections as listed in the product information: L1, L2, and ground from the power supply, then red, yellow, black, and ground to the motor.
Complete the transducer and pump connections according to the included instructions.
Verify the factory preset pressure setting and adjust within the stated 0-100 PSI range if needed.
Validate your login